A USB stick for the next restart
Rufus is useful when copying an ISO onto a flash drive is not enough. It prepares the device's boot structure and writes the chosen image in a form suitable for the selected target. The result might start an operating-system installer, a maintenance environment or another compatible boot tool. It does not supply a Windows license or guarantee that the software inside an image will support your hardware.
The current Rufus release is free and open source under GPLv3 or later. Pete Batard maintains the project through Akeo. The Windows executable runs without a conventional installation. Release 4.15 supports Windows 8 or later on the preparation computer, with separate x86, x64 and ARM64 builds. Choose that build for the computer running Rufus, not merely for the operating system you intend to install elsewhere.
Identify two different machines and one disposable target
The preparation computer runs the utility; the destination computer will boot from the finished USB. Their requirements are separate. Before writing, determine how the destination starts removable media and which image architecture it needs. Modern UEFI settings and older BIOS arrangements can require different media choices. The largest or newest setting is not automatically the right one.
Move needed files off the USB device because creating the medium can erase its contents. Match the device's name and capacity in Rufus and disconnect unrelated removable disks if that makes identification easier. A backup on another partition of the same selected device is not protected from rewriting that device. Confirm the physical target before the final start action.
Read the choices produced by the image
Select the image and allow Rufus to inspect it. Review the partition scheme, target system and filesystem in relation to the destination computer. Some images offer different writing approaches; follow the image publisher's instructions when they specify one. Do not force a filesystem just because it is familiar, since large files and firmware boot support can affect the appropriate choice.
For a collection of selectable images on one prepared stick, Ventoy follows a different workflow. For writing a ready-made disk image with fewer boot configuration choices, compare balenaEtcher. These are alternatives for particular jobs, not reasons to change utilities during an unexplained failure. First identify whether the problem concerns the image, the USB device or the destination firmware.
Check the boot before you need it urgently
Wait for Rufus to finish, close its operation cleanly and remove the device using the usual Windows procedure. Start the destination machine's one-time boot menu and select the intended USB entry. Merely seeing the stick in Explorer is not a test of boot compatibility. Stop at the installer or recovery environment's initial screen if your goal is only to verify the medium.
If no boot entry appears, compare the chosen firmware mode and media settings before rewriting repeatedly. If the environment starts but cannot see storage, the missing support may belong to that environment rather than Rufus. Keep the source image and a note of the successful settings. That record makes the next replacement stick easier to reproduce without guessing.